Guide
Artwork requirements: bleed, cut lines and file types
Print-ready artwork gets to proof faster. Here is what we check on every file, in the order we check it.
-
Make it the final size
Set up your file at the exact printed size, using the template or dieline for your product. If you need the dieline, contact us before you start.

Bleed, cut line and safe zone Add bleed
Run background colours and images 3 mm past the cut edge, unless your product template says otherwise. Bleed stops a thin unprinted edge showing if the cut moves slightly.
Keep a safe zone
Keep text, logos, QR codes and borders inside the safe zone, away from the cut, folds and seals. Thin borders close to the cut show every small movement, so either keep them well inside or run the design right out to the bleed.
Mark the cut line
For die-cut shapes, draw the cut path on its own layer as a spot colour named CutContour. Put special finishes on their own named spot layers too.
Check resolution, colour and fonts
- Images at 300 ppi at the final printed size.
- Print files in CMYK. Screens show RGB, so colours can shift: see RGB vs CMYK explained.
- Fonts outlined or embedded, linked images embedded.
-
Send the right file
PDF, .ai or EPS for vector artwork; PNG or JPG for images; SVG and WebP are accepted too. The product page takes files up to 10 MB each. Bigger file? Tick I will send my artwork after ordering and reply to your order confirmation email with the file.

Uploading on the product page
Not sure your file is right? Send it anyway: we confirm feasibility and any extra cost before print, and nothing is printed until you approve the proof. No artwork at all? Tick No artwork? Design it for me on the product page, or see our design services.